home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
PC Gamer (Italian) 35
/
PC Gamer IT CD 35 2-2.iso
/
utility
/
hmonitor
/
CHANGES.TXT
next >
Wrap
Text File
|
1998-09-16
|
2KB
|
68 lines
3.0.0.2 Shareware version
- Intel-made MBs are supported in registered version;
- min/max values for the current session are displayed as a hint (reg.vers.);
2.4.0.4
- bug with second CPU correction value fixed;
- Tyan Thunder2 S1696Dual is fully supported now.
2.4.0.3
- Warning message timeout is now measured in seconds and zero by default;
- Confirmation of exit added;
2.4.0.1
- Ability to select LM75 addresses added;
- Temp. sensors captions can be altered;
- Refresh interval is adjustable now;
- Individual temperature correction allowed for each sensor;
- Soyo mainboards are supported now;
2.3.0.1
- Second CPU temp. sensor data visible again;
- Core2 voltage grayed out for uniprocessor systems;
- MBs with Winbond chip wired only to ISA are fully supported;
- Supermicro MBs are supported now;
2.2.0.3
- Second CPU data are visible under Windows NT with multiprocessor support only;
- Form layout compacted for single CPU and only two fans;
- Program can work without LM78 on MB with Intel chipsets now;
- Program works with Winbond 83781 sensors chip;
- Program works with Asus non-Intel chipset based MBs;
2.2.0.1
- Main form layout altered;
- Settings form redesigned;
- Ability to read 2nd LM75 sensor added;
- Check of active driver added under NT;
2.1.0.7
- M/B temp was not displayed in hint for P-II motherboards in some cases;
- Nominal value for Vcore now can be from 2.0 to 3.5 volts;
2.1.0.6
- Only one instance of Hmonitor allowed.
- Hmonitor now works with LM79 (A-Bit BX6 MB)
2.1.0.5
- Bug fixed (CPU temp. compensation was not restored after restart)
2.1.0.4
- Ability to display Fahreheit temperatures added;
- "Large Fonts" support added;
- Bug with power fan divisor fixed.
2.1.0.2
- Some internal subroutines are rewritten;
2.0.2.0
- Warning messages are logged in Windows 95/NT Application Event Log.
2.0.1.0
- Giveio.sys replaced by new version (Thanks Dale!);
- Ability to set nominal value for I/O voltage added;
2.0.0.8
- Only one copy of Settings/About forms allowed;
- Default value for I/O changed to 3.5V;